Garage Floor Coatings in Montgomery, TX

Epoxy flake floors start from $5 per square foot with a $1,250 minimum. Flake garage floors start at $1,250 for a 1-car, $1,750 for a 2-car, from $2,750 for a 3-car and from $3,750 for a 4-car. The final price depends on the size, the condition of the slab and the finish, and the estimate is free.

Yes. We work throughout Montgomery, including the Lake Conroe communities of Bentwater, Walden, April Sound and Grand Harbor, along with the older neighborhoods near downtown.

Yes. We grind off old coatings and stains, repair minor to moderate cracks at no charge and flag structural issues before we start. Older slabs often need more prep, and we price that in the estimate.

We grind it off. Diamond grinding removes paint and old coatings and opens the concrete, so the new epoxy bonds to bare slab instead of the old layer.

Yes, and minor to moderate cracks are repaired at no extra charge. We fill and level them before any coating goes on, and we point out a structural problem before we start.

Repairs are filled and ground level before coating, and the flake pattern helps them blend in. If one will still show, we tell you at the estimate.

Yes. The polyaspartic top coat resists hot-tire pickup and cleans with a hose and a mop.

Wait until the slab is dry, not just 28 days old. We test the moisture in new concrete before we coat, and that reading tells us when the floor is ready. Coating too early can trap moisture and cause the coating to lift.

Yes. We inspect the slab, grind off stains and old coatings, repair cracks and then coat it, whether it is a house garage, a workshop or a barn floor.

Peeling almost always comes from poor preparation, not the coating. We grind the slab so the epoxy bonds into the concrete, and we back our workmanship with a 5-year warranty.

It is a clear, UV-stable coat that goes over the flake. It resists hot tires, chemicals and yellowing, and it gives the floor its shine.

You can, but a kit or garage paint rarely matches a professional job. Diamond grinding, a 100% solids epoxy base and a polyaspartic top coat are what make a floor last, and most kits skip them.

Yes. We coat patios and porches with a slip-resistant finish that is easy to rinse after a day on the lake.

Yes. Many homeowners add a patio or walkway to the garage job so it is one estimate and one project.

You can walk on it after about 24 hours and use it lightly after about 3 days. Full cure takes about 7 days at 68 F, so wait until then for heavy furniture and planters.

Most 1 to 2 car garages take about 2 days. Larger garages and shops take longer, and we confirm the schedule in your estimate.

Yes, clear it so the slab is open wall to wall. Move cars, bikes, shelving and storage out, and we handle everything from there.

No. Give us access to the garage or patio, then go about your day. We take care of the rest.

We grind with dust extraction and vacuum the slab, so the dust stays under control. We also clean up before we leave.

A garage has a roof over it, so garage work usually carries on, while patio and walkway days depend on the forecast. We watch the weather and reschedule an outdoor day if we need to.

Yes, within limits. The slab has to stay at least 5.5 F above the dew point, humidity has to stay under 85 percent and the temperature cannot run above 85 F, so we plan around the hottest afternoons and damp days.

Yes. Full cleanup and a vacuumed slab are part of every job, so you get your garage back ready to use.

Yes. We serve the historic business district and the neighborhoods around it, as well as the lake communities south and east of town.

Most likely. We work across Montgomery County and north Houston. Call 936-249-6985 and we will tell you whether we can reach you.

Hot tires lift cheap coatings. That is why we finish with a polyaspartic top coat over the flake and epoxy base, which stands up to hot tires after a summer drive or a day at Lake Conroe. A boat trailer or a truck parked in the garage is no different.

It depends on temperature and humidity, so we give you exact times for walking, light use and parking in your written estimate. Foot traffic comes sooner than vehicles, and we will tell you plainly when the car can go back in. A floor that cures fully lasts longer.

Sweep or dust mop, then wash with a soft mop and a mild pH-neutral cleaner. Skip harsh solvents and abrasive pads, and wipe up oil and chemicals soon after a spill.

Our 5-year warranty covers our workmanship, which means the prep and the installation. If the coating fails because of how we installed it, such as peeling or lifting, we make it right. It does not cover damage from outside causes like impact or chemical spills left to sit.

Our own crew does every job. Nothing is subbed out, and we oversee the work from start to finish.

No. The 5-year workmanship warranty covers the original customer and does not transfer to a new owner.

No. The estimate is free, with no obligation, and you get the price in writing. You talk with the owners directly.

Yes. We bring flake samples to your estimate so you can see the colors in your own light. The blend you choose becomes final once material is ordered, so pick at the estimate.

Flake blends hold their color well because the color lives in the flakes sealed under a UV-stable polyaspartic top coat, not in a plain pigment at the surface. That matters for an epoxy garage with the door open to afternoon sun and even more for epoxy patios and walkways in full sun. Our guide to epoxy floors in Texas heat and humidity covers how we plan for it.